Fountain pens are very convenient and economical because they can be used for a long time, as long as you know how to replace the ink when it runs out. Depending on the structure, we use different ways to install fountain pens for the most accurate results. Detailed information will be compiled and introduced to you in Concopens‘s fountain pen installation instructions below.

 

How to install fountain pen ink 

In the diverse market, fountain pen products are also extremely rich. You can buy and use a convenient pre-filled pen with ink cartridges or choose a fountain pen that uses refillable ink according to your preference. Regardless of the type, users need to understand how to properly insert ink into a fountain pen to operate when necessary to best serve their needs.

– How to install utility fountain pen ink

For fountain pens that use prefilled cartridges, how to install a fountain pen will be done through the following steps:

– Step 1: For newly purchased pens, remove and wash the pen barrel with clean warm water to remove machine oil to preserve the pen before use. After that, you proceed to dry. As for used pens, you should only remove and clean them when necessary.

– Step 2: Remove the ink cartridge of the pen. Pull out gently, do not twist the part with the piston attached.

– Step 3: Install the replacement utility ink cartridge. In this operation, you only need to pay attention to inserting the small end of the waist into the back part to match, then rotate the pen shell tightly to the pen neck.

– Step 4: Lightly flick the pen downward, so that the tip of the nib is facing vertically downward. This step is only for fountain pens with ink cartridges installed for the first time only. Particularly for fountain pens that are in use and have had their ink replaced, next time you just need to remove the old tube. and replace the new convenient ink cartridge according to the correct procedure and you’re done.

– How to install an ink fountain pen
For fountain pens that use pump ink, we need an ink cartridge and install the ink according to the following process:
– Step 1: The user disassembles the pen shell to reveal the small plastic ink tube inside.
– Step 2: Place the pen in a cup of clean warm water and rotate the ink tube to suck water in to clean the ink tube. After that, you dry the details.
– Step 3:  Open the lid of the prepared fountain pen ink bottle
– Step 4: Place the tip of the nib down into the ink cartridge to a sufficient depth, then gently and slowly rotate the ink tube from left to right to let the ink flow in. in the tube.
– Step 5: Lift the pen tip out of the ink bottle after injecting the necessary amount and clean the ink if there is dirt on the outside. Finally, you reinsert the pen shell as before, gently shake the ink down, and you’re done and ready to use.

How to install a fountain pen nib

In case you need to replace a fountain pen nib, you should also refer to the correct way to install the nib to avoid wasting time and effort as well as avoiding wasting money due to problems. damaging the pen nib by doing it incorrectly. Accordingly, you need to proceed sequentially as follows:

– Step 1: Clean the pen thoroughly before replacing the nib with clean, warm water. You can soak the fountain pen nib for a moment to help remove the preservative oil.

– Step 2: Dry and drain the pen with tissue paper or a soft, dry, clean towel

– Step 3: Disassemble the nib by using pliers with enough force to clamp the pen nib out. Before that, you can roll up some dry multipurpose paper or use a soft cloth around the tongue position on the tip of the pen nib to avoid direct friction.

– Step 4: Install nib bThe youngest just entered and it’s complete. Note that when removing and installing the nib, you must observe and place it in the correct direction and install it 

 

Within the scope of this article, you have been guided in two aspects, including: how to install fountain pen ink and how to install fountain pen nib. Each piece of content provides detailed general information so that users can operate quickly, easily, and accurately. Hopefully this reliable information from Concopens will help you solve the problem you encounter in the most effective way.